Entering Geofence area
The Geofence area is a like fence drawn around the SmartAccess Module. When entering KeylessGo get’s armed. The SmartAccess App starts scanning for a SmartAccess Module.
If KeylessGo is not activated within 15 min after entering the Geofence area you need to leave the Geofence and reenter to enable KeylessGo again.
Nevertheless opening the door manually via the SmartAccess App still works.
Approaching door
entering Bluetooth area
The Bluetooth area is the area in which the SmartAccess Module can communicate with the smartphone via Bluetooth. When entering this area the SmartAccess App establishes a connection to the SmartAccess Module or door. Inside this area the door can be opened via the SmartAccess App.
If KeylessGo is not used within 1 min after activation you need to leave the Geofence area and reenter to enable KeylessGo again.
Nevertheless opening the door manually via the SmartAccess App still works.
Note: The transmission power and reception characteristics of the SmartAccess Module depend heavily on constructional and environmental conditions. Thus, the range in the open field differs from that in buildings. Also, the signal is transmitted differently at high humidity than at lower humidity.
Grabbing the door handle or touching the sensor
The door unlocks and can now be pushed open.
With Auto unlock enabled the door can be pushed open without grabbing the door handle or touching the sensor.
After opening the door
The latch gets extracted immediately after opening the door.
Closing the door
After closing the door get’s fully locked again
Functionality depends on lock type
(All motorised FUHR locks support this feature).